How to Hang Tiles on a Wall

Aarohi Ahuja
3 min readJul 23, 2021

The concept of tiling your own walls may seem overwhelming, but with the correct preparation and the right equipment, it’s a lot easier than you think. In this article, we’ll show you how to tile a wall, step-by-step process so that you can do it on your own effortlessly.

Nothing beats the beauty of well-designed tile wall tiles. Tile walls are most commonly found in bathrooms or as splash guards on kitchen cabinets, but they may be utilised decoratively anyplace a wall has to be tiled. Although the prospect of installing a tile wall on your own may sound daunting, you may divide the procedure down into steps to make it appear less frightening, such as choosing a design, hanging the tile on the walls, and applying the grout.

Also, make sure to use high-quality wall tiles from reputed tile manufacture to avoid any disaster later on. One of the most reputed tile manufacturers in India is AGL Tiles, and they also have a wide range of products to choose from, so make sure to check their website.

How to Hang Tiles on a Wall:


  • Wall Tiles
  • Tile Adhesive
  • Grout

Protective Gear:

  • Safety Glasses
  • Dust Mask
  • Latex Grip Safety Gloves


  • Notched Trowel
  • Measuring Tape
  • Tile Spacers
  • Tile Cutter
  • Tile Nippers
  • Grout Remover
  • Grout Float
  • Cold Chisel
  • Masking Tape
  • Cloth
  • Mixing Bucket
  • Rubber Mallet
  • Hammer
  • Masonry Nails
  • Hacksaw

How to Hang Tiles on a Wall

  • Apply a layer of glue to the wall that is 18 inches (0.32 cm) thick. Begin putting the glue at a bottom corner about 1 tile length away from the bottom and sides of the wall, leaving room for the edge floor tiles. Scoop a golf ball-sized amount of glue onto a notched trowel and apply enough adhesive in a thin layer on the wall to hang 2–3 tiles at a time.
  • You may need to go over the glue with the trowel a few times to ensure that it’s thin and level. Pre-mixed glue is less costly and ideal for wall tiling. If you bought a powder adhesive, mix it according to the package recommendations until it has the consistency of peanut butter.
  • Make grooves in the glue using the trowel. Keep the trowel at a 45-degree angle to the wall. To form the grooves, move the trowel horizontally across the wall, providing steady pressure as you distribute. This will produce the ridges in the glue that are required for the tile design to adhere to the wall.
  • Check the adhesive box to ensure you’re using the correct sized notches for the ceramic tiles to attach to the glue. Most trowels feature two sets of notches of varying widths.
  • Continue the row with more glue and tiles after hanging the first marble tile. Line up your first tile carefully and push it into the glue, twisting it slightly to generate suction before placing it in its place. Then, continue to place tiles in rows or columns according to your pattern. Apply extra glue to the wall once you’ve covered the majority of it, and then continue hanging tiles in your design.

Remember to work in tiny portions at a time, putting glue just where you’re tiling. You may need to use a wet cloth to remove the glue that has oozed out from between the polished tiles.



Aarohi Ahuja

I am experienced writer. My skills specifically based on writing as well as article , essay writing, report writing, academic writing, thesis & dissertation.